Robotics Sportster Flash x2 Manual de usuario descargar pdf (Pagina 13)

Appendix B - Enabling x2 in USR Products

With the exception of products shipped as x2, all U.S. Robotics products need to have

updated firmware installed and the feature enabled. The MP I-modem and NETServer I-

modem family of products need only to have updated software, they do not need to be

enabled. The method of obtaining that software, and enabling the feature, varies by

product.

Courier V.Everything (Analog)

1. Get the latest x2 code from http://totalservice.usr.com/upgrade/

2. Send the code to the modem using either SDL or an XMODEM file transfer.

3. Call U.S. Robotics host to enable x2.

4. Enter AT&F1S0=0&W

5. Turn the modem OFF and then back ON.

6. Enter ATI7 and look for x2 in the options:

Options HST,V32bis,Terbo,VFC,V34+,x2

Sportster

The only way to upgrade Flash-upgradeable Sportsters is to use the Flash Gordon utility.

The Flash Gordon utility is currently available through resellers.

Sportsters without Flash memory require a chip update which will require customers to

contact Customer Support using the Internet or by phone at (847) 982-5151.

Sportster 128 ISDN

This is not an analog-capable product and there are no plans for x2 support.

Total Control Quad Digital (and Analog/Digital) modems

1. Get a feature key for your chassis from http://totalservice.usr.com (The web site

will ask you for your NMC’s serial number and you’ll get back a feature key that

will enable x2 in all of the modems in that chassis.)

2. Update all system components to TCS2.5 (or later), in the following order:

• TCM 4.3.1 (or later)

• NMC 4.3.1 (or later)

• Quad Modem 5.0.7/5.1.7, or Quad I-modem 1.0.5/1.1.5 (or later)

• T1 card (PRI 2.5.1 or Channelized T1-386 4.1.5) or later

3. Through TCM software, run Actions | Software Command | Restore From

Default.

1 2 ... 8 9 10 11 12 13 14

Sin comentarios

Robotics Sportster Flash x2 Manual de usuario Pagina 13