Robotics Sportster Flash x2 Guía de usuario descargar pdf (Pagina 24)

20 Sportster Flash x2 - User’s Guide

Limiting the Lowest Possible Connect Speed

The &U command allows you to limit the lowest possible connect

speed. If a remote modem attempts to connect to your Courier with x2

at a speed lower than &U, your Sportster with x2 will not allow it to

connect.

To limit the Use this command Where x is

Lowest possible

connect speed

AT&U=x A value from 0 to 31

Note: See table 12.4 for a list of connect speed values.

Limiting a Range of Possible Connect Speeds

By setting &N and &U values, you can limit the range of speeds at

which your Sportster with x2 connects. If a remote modem does not

connect to your Sportster with x2 at a range between the speeds

designated by the &N and &U commands, your Sportster with x2 will

not allow it to connect.

Note: The link speed associated with the &U argument cannot be

greater than the link speed associated with &N argument.

Use the following table to understand the relationship between &U and

&N commands:

If &U And &N Then your modem

Equals

zero

Equals zero Connects at the highest possible

speed.

Is greater than

zero

Connects at the &N speed only.

Is greater

than zero

Is greater than

zero and greater

than &U

Connects at the highest possible

speed in the range from &U to &N.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 70 71

Sin comentarios

Robotics Sportster Flash x2 Guía de usuario Pagina 24