Robotics Sportster Flash x2 Guía de usuario descargar pdf (Pagina 60)

56 Sportster Flash x2 - User’s Guide

S-Registers

To change a setting, use the ATSr=n command, where r is the register

and n is a decimal value from 0*255 (unless otherwise indicated).

S0 1 Sets the number of rings on which to

answer in Auto Answer Mode. When set

to 0, Auto Answer is disabled.

S1 0 Counts and stores the number of rings

from an incoming call (read only).

S2 43 Stores the ASCII decimal code for the

escape code character. Default character

is "+."

S3 13 Stores the ASCII code for the Carriage

Return character <CR>.

S4 10 Stores the ASCII decimal code for the Line

Feed character <LF>.

S5 8 Stores the ASCII decimal code for the

Backspace character <BS>.

S6 4 Sets the number of seconds the modem

waits for dial tone before dialling.

S7 60 Sets the number of seconds the modem

waits for a carrier or answers before

returning on-hook and sending a No Carrier

result code.

S8 2 Sets the duration, in seconds, for the pause

(,) option in the Dial command.

S9 6 Sets the required duration, in tenths of a

second, of the remote modem’s carrier signal

before recognition by your modem.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 70 71

Sin comentarios

Robotics Sportster Flash x2 Guía de usuario Pagina 60